Durable And
Decorative
PRODUCTS IN THIS SOLUTION
DAUMANT MANTELFIX
DAUFORM DECOMIN-LINEMIN
PROCESS STEPS
Solution Products
Would it be a lot if you ever asked for a product which will replace both the products of thermal insulation board adhesive and thermal insulation plaster? What if this product also contributes to thermal insulation performance?
With DAUFORM Decomin and Linemim you can create eye-catching and alternative textures on the inner and outer surfaces of your buildings!
Step-1
First, mix the mortar in the Daumant Mantelfix package with 5.5-7 liters of water at low speed. Let the mixture rest for a few minutes and then repeat the mixing process.
Step-2
Your application surface must be clean and free of adhesives. Apply mantelfix to this clean surface and insulation material (XPS / EPS) and stick together.
Step-3
After fixing XPS / EPS, re-apply mantelfix to the surface and fix your net.
Step-4
Use Mantelfix again on the last floor.
Step-5
Two days after application your surface will dry. Then it will be ready for painting etc.
Step-6
Thus, you can complete the insulation mortar and adhesive application with a single product.
Step-7
Mix the Decomin or Linemin package from the Dauforum mineral plaster family with 5-6.5 liters of water
Step-8
Mix with a low speed mixer so that no lumps remain. Leave for 2-3 minutes to mature. Mix again after resting
Step-9
Apply to the surface with a steel trowel. Attention! The mortar should be evenly distributed
Step-10
Your surface is now ready with Daumer